A dynamic lane merge system deployed outside Detroit was found to be cost-effective based on an analysis of system cost and motorist time and fuel savings.

Case study on reducing aggressive driving and optimizing throughput at work zones in Michigan

October 2004
Detroit; Michigan; United States

Summary Information

In the summer 2002 and 2003, the Michigan DOT rebuilt a 13.5-mile section of I-94 in the suburbs of Detroit. To help smooth traffic flow, the DOT deployed a dynamic lane merge (DLM) system. The system was designed to regulate merging movements in transition areas where lane configurations changed from three lanes to two lanes. A series of five DLM trailers equipped with microwave traffic sensors, wireless communications, and "Do Not Pass When Flashing" static signs with flashing beacons were installed upstream from the work zone at 1,500 foot increments. When traffic queues developed on the approach and traffic conditions degraded beyond pre-set threshold limits, the system automatically activated flashers on DLM signs to promote early merging. Once activated, the flashers continued operating for a minimum of five minutes. In addition, a state patrol officer was on site to promote compliance, several static signs showing the message "Do Not Pass" and "Form Two Lanes" were posted on the approach, and a portable dynamic message sign with a large arrow and a "Merge" message was strategically placed in the transition area.


The DLM system was most effective at peak hour traffic volumes of 3,000 to 3,500 vehicles per hour. The study found that if traffic volumes were consistently below or above these levels the system would have limited effectiveness. With low traffic volumes, merging control would most likely not be needed; and with higher traffic volumes, the resulting queues lengths would be so long that the flashers would operate continuously and the automated system would not be needed.

Probe vehicle runs and traffic data were collected by Michigan DOT and Wayne State University.

A cost-effectiveness analysis found the DLM system was cost effective given that a dollar value estimate of delayed motorist time exceeded $3.33 per hour. The analysis consisted of multiplying the value of motorist time by the travel time saved, adding the related fuel savings, and comparing this value to the actual cost of the system.

Benefit Comments

No comments posted to date

Comment on this Benefit

To comment on this summary, fill in the information below and click on submit. An asterisk (*) indicates a required field. Your name and email address, if provided, will not be posted, but are to contact you, if needed to clarify your comments.


Intelligent Transportation Systems in Work Zones: A Case Study - Dynamic Lane Merge System

Author: Scriba, Tracy, and Tim Luttrell

Correspondence with Jeff Grossklaus, Michigan DOT (November 2006 and January 2007)

Published By: Federal Highway Administration, U.S. DOT

Prepared by SAIC for the U.S. DOT

Source Date: October 2004

EDL Number: 14011



Average User Rating

0 ( ratings)

Rate this Benefit

(click stars to rate)

Goal Areas


Typical Deployment Locations

Metropolitan Areas


smart work zone systems, smart work zone, smart work zones, Smart work zones, workzone, WZ, Dynamic Message Signs, CMS, VMS, Changeable Message Signs, Variable Message Signs, construction warning signs, Portable Dynamic Message Signs, portable CMS, portable VMS, portable Changeable Message Signs, portable Variable Message Signs, Temporary Dynamic Message Signs, Temporary CMS, Temporary VMS, Temporary Changeable Message Signs, Temporary Variable Message Signs

Benefit ID: 2007-00402